Verify that you are using the correct AHCI or RAID system drivers for your SATA option.Įnable SATA AHCI Support - enables the embedded chipset SATA controller for AHCI - THIS IS WHAT YOU NEEDĮnable SW RAID - enables the embedded chipset SATA controller for the HPE Smart Array S100iSR Gen10 SW RAID. Press the F9 key in the ProLiant POST screen.įrom the System Utilities, select System Configuration > System Options > SATA ControllerOptions > Embedded SATA Configuration > Enable SW RAID and press the Enter key. Creates and sets up HPE SmartCache to accelerate. Enable HPE SSD Smart Path to improve Solid State Drive (SSD) read performance by bypassing the Smart Array firmware for the optimal performance path to the SSD. Deploys and manages HPE Secure Encryption, a data protection solution. You must be inSoftware RAID mode to use the Smart Array S100i SR Gen10 SW RAID solution on the embedded SATAports. Expands storage capacity in an array or change RAID levels. ![]() The embedded SATA ports may be configured in AHCI mode or Software RAID mode. Take out the Raid card, and connect the cables to the onboard controller, and do the flowing: ![]() PS: Also you cold try this, but look on you motherboard if you have any more 2 sff connectors.
0 Comments
Leave a Reply. |